SOSP-600 - How to Replace the Rear Door Lanyard Connector
If the Lanyard Connector that connects the backdoor on your Gemini SOSP-600 waterproof Bluetooth speaker gets damaged or worn out, you can replace it yourself with just a few basic tools. This guide walks you through the process, step-by-step.
⚠️ Tools you’ll need:
- A clean flat surface
- Sharp tweezers or a similar tool
- A small electric screwdriver
- Your replacement lanyard fixture
- Save your original screw and silicone plug — you’ll reuse them!
Step 1: Prepare Your Workspace
- Lay the SOSP-600 flat on a clean surface with the back side facing up.
- Make sure the surface is soft or covered so you don’t scratch the speaker.
Step 2: Remove the Old Lanyard Fixture
-
Remove the silicone plug using tweezers.
Be gentle, and keep the silicone plug — you’ll need it again at the end.
- Use a small electric screwdriver to remove the screw holding the old lanyard connector in place.
Keep the screw safe — you’ll reuse it for the new part. - Carefully lift and remove the old fixture.
Step 3: Install the New Lanyard Fixture
- Place the new lanyard fixture where the old one was.
- Insert the original screw into the holes and tighten them with your electric screwdriver.
-
✅ Recommended torque: 1.0 ±0.2 KGF·CM
(If you're not sure how much force that is, just tighten snugly — not too loose, not over-tightened.) - Push the silicone plug back into place to seal everything up.
You’re Done!
Your SOSP-600’s lanyard fixture is now as good as new. You’re ready to clip it onto a backpack, carry it to the beach, or hang it poolside.
Need More Help?
If you’ve tried the steps above and still need assistance, contact Gemini Support:
Phone: 732-346-0061
Email: support@geminisound.com
Web: support.geminisound.com